Welcome to My Blog

Hi! I’m Sophorn. Welcome to my blog. I love sharing to all friends who would like to know me about the experiences in 🔌electronic & ⏧telecommunication knowledge in Cambodia. I’m a electronic technicians who had an experiences in telecom field for 10 years in Cambodia and most of my job for these days based on Technical Support for hardware GSM, WCDMA & LTE in both NOKIA & HUAWEI Vendors. I can’t wait to get to know you.😊

Comments

Post a Comment

Popular posts from this blog

4- Amplifier Distortion

Image
Amplifier Distortion Amplifier Distortion can take on many forms such as Amplitude, Frequency and Phase Distortion due to Clipping. For a signal amplifier to operate correctly without any distortion to the output signal, it requires some form of DC Bias on its Base or Gate terminal. A DC bias is required so that the amplifier can amplify the input signal over its entire cycle with the bias “Q-point” set as near to the middle of the load line as possible. The bias Q-point setting will give us a “Class-A” type amplification configuration with the most common arrangement being the “Common Emitter” for Bipolar transistors or the “Common Source” configuration for unipolar FET transistors. The Power, Voltage or Current Gain, (amplification) provided by the amplifier is the ratio of the peak output value to its peak input value (Output ÷ Input). However, if we incorrectly design our amplifier circuit and set the biasing Q-point at the wrong position on the load line or apply too
Read more

16- Common Collector Amplifier

Image
Common Collector Amplifier Common Collector Amplifiers produce an output voltage across its emitter load which is in-phase with the input signal The  Common Collector Amplifier  is another type of bipolar junction transistor, (BJT) configuration where the input signal is applied to the base terminal and the output signal taken from the emitter terminal. Thus the collector terminal is common to both the input and output circuits. This type of configuration is called Common Collector, (CC) because the collector terminal is effectively “grounded” or “earthed” through the power supply. In many ways the common collector configuration (CC) is the reverse of the common emitter (CE) configuration as the connected load resistor is changed from the collector terminal for R C  to the emitter terminal for R E . The common collector or grounded collector configuration is commonly used where a high impedance input source needs to be connected to a low impedance output load requiring
Read more